Slicer Discord
Pet Portal – 3D-Druckmodell von MakerWorld MakerWorld
Pets

Pet Portal

von Loch · Pets
36 Downloads
56 Likes
18 Makes
Zum Modell
The Pet Portal!A flexible tunnel for your pet to play in! Use any blanket or large towel to make a flexible tube for your pet. Easy to clean! Just remove the blanket and put it in the washing machine. Designers noteOur bunny Jack was digging through our blankets on the sofa a lot so I went to find something for him online, but I only found hard round “cat” tunnels which aren't really washable. So I I designed something from scratch. The base is printed on the front face so that the portal is strong. Now your pet can even stand on it. The screws have flat sides so they can be printed on their sides for strength. They need support on those flat sides. No support needed for the base part, as it is designed such that it can be printed without and gives a cleaner result on the thread. Dimensions are shown belowAssembly InstructionsTake the screws through the hole in the clamp and screw it in the base on both sides. Fold the edge of a towel or blanked from the top over the sides and loop
Kategorie
Pets
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

4 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen