MakerWorld
Test Models
Go to Model
PETG/PLA interface support and overhang test
95
Downloads
9
Likes
59
Makes
i needed to tune in my pla support interface for my petg prints and at the same time needed to tune in the overhangs and bridging this AIO print only takes 30 mins and is a great way to quickly tune several things at once. can also be used to tune petg as a interface layer for pla support just switch filaments in the slicer.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
