Thingiverse
PGYTECH Tablet Holder Accessories
von aliveathome
9
Downloads
6
Likes
0
Makes
This part is for the PGY-TECH Tablet Holder for the DJI Mavic controller (https://www.pgy-tech.com/pad-holder-for-spark-and-mavic-pro).
There is a problem with the design of this tablet holder. If you tilt your controller forward the weight of the attached tablet will make the arm of the holder tilt forward until it hits the controller. This part will prevent it from happening.
You also need this:
1 pcs M4x20 Hex screw
1 pcs M4 nut
Soldering iron or similar
Heat the screw and nut with the soldering iron and melt them into place.
Printed in green PLA for display purposes. Print in black for a stylish look :)
There is a problem with the design of this tablet holder. If you tilt your controller forward the weight of the attached tablet will make the arm of the holder tilt forward until it hits the controller. This part will prevent it from happening.
You also need this:
1 pcs M4x20 Hex screw
1 pcs M4 nut
Soldering iron or similar
Heat the screw and nut with the soldering iron and melt them into place.
Printed in green PLA for display purposes. Print in black for a stylish look :)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
