Thingiverse
Philips Hue Motion Sensor rod mount
por ioio72
13
Descargas
2
Likes
0
Makes
Attach your Philips Hue motion sensor to the rod system of Ikea's obsolete Grundtal rods or any rod with a diameter of 16 mm.
The mount snaps onto the rod and the center of gravity helps adjust the hanging angle to your liking.
You must first snap the bracket in place, and then attach the Hue Motion Sensor using a 19.8mm screw.
**Note:** It is a good idea to print this model lying on its side on the heating bed to get better durability for the snap mechanism.
The mount snaps onto the rod and the center of gravity helps adjust the hanging angle to your liking.
You must first snap the bracket in place, and then attach the Hue Motion Sensor using a 19.8mm screw.
**Note:** It is a good idea to print this model lying on its side on the heating bed to get better durability for the snap mechanism.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!