Philips SureSigns VS2+ stand support

This is the support screwed to the wheeled stand for the Philips SureSigns VS2+ vital signs monitor. This is intended to be a bit more resistant than the original one, which has two little winglets that break easily when moving the monitor around.
For the locking screw in the higher part, I drilled up half of the hole with a 6.5mm drill and heat-pressed a nut to have a 4mm screw instead of the original pin, but I'll fix this later.
I printed it in Treed Healthfil Structura MA, a strong PA-CF medical filament guaranteed for skin contact.
Test/stress out the part a lot when firts mounted to have an idea of the quality, if you like it substitute it with another identical one to be sure it is in new-like conditions.