Thingiverse
Phiolent case lock clip
von Elfl0rd
0
Downloads
0
Likes
0
Makes
Locking clip for Phiolent cases. Fits at least jigsaw "ПМ7-750Э М" perfectly.
I broke the original case latch and couldn't glue it back together because the material is only 2 mm thick at the break point and the load causes it to tear.
So I made a 3D model of this clip with greater thickness.
Printing is simple, print standing up, on the side with the finger rest, turn on the skirt if you have adhesion problems.
A 15% infill works for me, it hasn't broken yet.
Good luck!
p.s.
There is only one model, as the clip fits both sides of the case, so you DO NOT NEED to mirror the clip to print the second one.
I broke the original case latch and couldn't glue it back together because the material is only 2 mm thick at the break point and the load causes it to tear.
So I made a 3D model of this clip with greater thickness.
Printing is simple, print standing up, on the side with the finger rest, turn on the skirt if you have adhesion problems.
A 15% infill works for me, it hasn't broken yet.
Good luck!
p.s.
There is only one model, as the clip fits both sides of the case, so you DO NOT NEED to mirror the clip to print the second one.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
