Slicer Discord
Phone Charge Orientation Stand – 3D printable model from MakerWorld MakerWorld
Gadgets

Phone Charge Orientation Stand

8 Downloads
2 Likes
2 Makes
Go to Model
SummaryDon't like your phone charger that doesn't help locate your phone to the right area. Well you're in luck. My wife didn't either so i solved the issue. I picked up the Ubio Labs wireless charging pad at costco, but my wife wouldn't pay much attention to the phones location on the charger, therefore often would not get the charge she was expecting. this holder will not only hold your phone upright, but places the charger in the right location. The charging pad fits very nice and has a pass through for the power cord and a USB type plug to go under. No cable fighting . simple slip the power cord from the back, plug it in, then press the charger into the stand.UPDATED: now phone can lay on its side and charge. it is also quicker to remove your phone from the stand as the upper half is in the open.Print SettingsNotes: Print as if you have the stand on a table holding a phone. Supports were for the under hangs for the phone shelf and the wire pass through.
Category
Gadgets
Source
MakerWorld
Published
Updated
What you need to print this: Beginner Low confidence
Single piece
Supports 1/3
Assembly 0/3
Settings 1/3
Bed size 0/3
Post-process 0/3
Printer
FDM / FFF
File format
STL
Material
PLA, ABS
Software
Cura, PrusaSlicer, or similar
No ratings yet
No comments yet – be the first!

Similar Models

6 Suggestions
Feed Blog Slicer Cost Calculator Image Search Submit Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Add to Collection