Slicer Discord
Phone Charging Cooling stand – Modelo 3D imprimible de Thingiverse Thingiverse

Phone Charging Cooling stand

por Skyhigh24
0 Descargas
2 Likes
0 Makes
Ver Modelo
With all of the newer Quick Charging Techniques used by Phone Manufacturers,
the Power Delivered to the Phone is enormus.

Even if it is nice to have a Full Battery within 20 Minutes this generates a lot of Stress and Heat from the Charging Circuit and Battery.

The Battery Itself doesn´t like Temperatures above a given Temperature (40°C most of the Time)so its capped, if the Cap-Value is reached the Current flowing through is Limited.


This made me Think a little and i experimented with Cooling the Phone while Charging.

The Effect was much more than expected, the Phone was Full 25-30minutes earlier, than without cooling.

Some Friends liked the Idea so i also printed them the cooling Stand and they tested it.
The Impact wasnt the same on every Phone so your milage may vary.

In average the Battery stayed 4-9°C cooler and the Phones were full 8-16Minutes early.


The saved Time isnt worth that much, but the Lower Temp of the Battery is.
If the Battery stays co
Fuente
Thingiverse
Lo que necesitas para imprimir: Principiante Baja confianza
Pieza única
Soportes 1/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 0/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
Software
Cura, PrusaSlicer o similar
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!

Modelos similares

6 Sugerencias
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección