Thingiverse
Phone Charging Stand
113
Downloads
110
Likes
0
Makes
A stand to support your phone. Cutouts should allow most cords and chargers to fit. Recommend rotating 90 degrees (so it is on its side) before printing to avoid most structural supports.
See http://www.thingiverse.com/thing:1148116 for a customizable version - note that without a "lip" it is possible for phones to slide off when not plugged in...
See http://www.thingiverse.com/thing:1148116 for a customizable version - note that without a "lip" it is possible for phones to slide off when not plugged in...
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
