Slicer Discord
Phone Holder "Exagon" V2 – 3D-printbaar model van MakerWorld MakerWorld
Gadgets

Phone Holder "Exagon" V2

door SMatty · Gadgets
894 Downloads
188 Likes
343 Makes
Model downloaden
Hi, I would like to introduce you to my New Phone Stand Exagon V2This is a rivisited version of the first model that has been highly appreciated by users.I hope you like it. Good Print ! If you have any problems with adhesion you can try turning off aux fan when printing PLA You can find the first version herehttps://makerworld.com/en/models/193049#profileId-214820 You can find the raised version (allow charging) herehttps://makerworld.com/en/models/397838#profileId-299273 If you like my project consider supporting my job with a boost. Thank you ! Attention A1 series :In some cases only on the A1 series someone has reported problems. I tried various prints on my A1 mini without problems, like other users, but someone has reported problems.I don't understand what the problem could be generated (firmware? slicer? bed slinger? air flows?)I don't think it's a profile problem but I can suggest if you want to try to use a standard profile 0.2
Categorie
Gadgets
Bron
MakerWorld
Gepubliceerd
Bijgewerkt
Wat je nodig hebt om te printen: Beginner Lage betrouwbaarheid
Waarom?
2 kleuren
Eendelig 2 kleuren / AMS
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 0/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PLA
Kleuren
2 (AMS/MMU aanbevolen)
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie