Phone holder or kickstand

Phone holder/ kickstand

A simple and highly customizable design

Instruction

Print all the parts bottom, center hinge, and top plate (there are multiple options for top plate check before printing)
Remove the supports and clean the parts you might need to drill the holes using a 2 mm drill
Use a marker and mark the poles on the magnets
Use super glue and stick the magnets to the printed parts make sure the poles on the bottom part are oriented in the same direction and the other two parts have the opposite of that so that they can stick
Assembled everything using the 2mm pins
If the pins are loose you can add a small drop of superglue at one end before pushing it in completely
Find a comfortable position and stick it to your phone using the VHB tape
(note: use a phone case if you are not sure about it)

Things you need
3d printed parts
2x 2mm dia 22mm long pins(i used a pin from a rivet)
2x 5mm dia 2.8mm long strong neodymium magnet
2x 5mm dia 0.8mm long strong neo