Phone Holder

This is a phone holder I designed. It's super sturdy and it sits at a nice angle and has a slot for the cable to run through. The holes through the sides are a neat little design element and they reduce the amount of plastic required. I printed mine in PLA on my Anet a8 and it works great.

You will notice that I have little .9mm supports on the bottom. This is so you can print with a brim on the first layer and it holds all 4 pieces of the legs together while you print, until they come together about 1/3 way through the print. You can then just cut this off like normal and she's good to go.

8-18-2017: A few folks have told me that their cables don't fit through the slot, so I updated the model to make the space bigger for USB cables