Thingiverse
Phone Holder Wall & Ceiling
von CDeviant
3
Downloads
3
Likes
0
Makes
Max tolerance for fitment is 3.5" wide, .5" thick. It likely will fit phones .125" thinner.
It is specifically designed for the Huawei Ascend Mate 2, with case.
Supports are needed for the overhang.
0.3 resolution worked fine.
Should print in about 1hr 20min
It is specifically designed for the Huawei Ascend Mate 2, with case.
Supports are needed for the overhang.
0.3 resolution worked fine.
Should print in about 1hr 20min
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!