Thingiverse
Phone or Tablet Stand
door SpinnersByColleen
4
Downloads
2
Likes
0
Makes
Simple and useful phone or tablet stand, designed to accommodate devices with or without a case. It has 5 slots of varying width, (roughly 8mm, 9mm, 10mm, 11mm, and 12mm).
All the slots are angled at about 6 degrees. Your device and be tilted forward or back; just spin the stand around!
No support. Infill can be fairly low.
Your print settings will affect the slot widths slightly. Consider scaling the object up or down slightly if the largest one isn't big enough or the smallest one isn't small enough...
All the slots are angled at about 6 degrees. Your device and be tilted forward or back; just spin the stand around!
No support. Infill can be fairly low.
Your print settings will affect the slot widths slightly. Consider scaling the object up or down slightly if the largest one isn't big enough or the smallest one isn't small enough...
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
