Thingiverse
Phone stand (minimalistic form factor)
di MalteBY
14
Download
6
Likes
0
Makes
This is a simple small format mobile phone holder that can be easily built without screws.
To connect the two halves:
1. Take a piece of your 1.75mm filament and cut it so that there is about 2mm left on both sides
2. Place the piece as an axis through the hinge.
3.Melt the filament with a lighter and press it flat with the side so that the end can no longer slip through
4. Perform this step on the other side
To connect the two halves:
1. Take a piece of your 1.75mm filament and cut it so that there is about 2mm left on both sides
2. Place the piece as an axis through the hinge.
3.Melt the filament with a lighter and press it flat with the side so that the end can no longer slip through
4. Perform this step on the other side
MalteBY pubblica anche su
5 modelli aggiuntivi su altre 1 piattaforme
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
