Thingiverse
Phone Stand MK1
door truthmonger
4
Downloads
2
Likes
0
Makes
A simple phone stand for a table top. This particular model has a very specific center hole to fit a very specific phone with a very specific pop-socket mounted near the bottom and off center.
(Translation: My mother was visiting, could use a phone stand, and had never seen a resin 3D printer run before.)
It ran easily on its base without any supports.
(Translation: My mother was visiting, could use a phone stand, and had never seen a resin 3D printer run before.)
It ran easily on its base without any supports.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
