Slicer Discord
3DSEARCH / Other Tools / Phone stand
Phone stand – 3D printable model from MakerWorld MakerWorld
Other Tools

Phone stand

by Nevr · Other Tools
3 Downloads
1 Likes
1 Makes
Go to Model
The hole for the phone is about 1.35 cm thick (0.52 inches) so if your phone is a lot over or under that then it probably wont work. The holders do work fine alone in landscape, but for portrait you do need 2.
Category
Other Tools
Source
MakerWorld
Published
Updated
What you need to print this: Beginner Low confidence
Single piece
Supports 1/3
Assembly 0/3
Settings 1/3
Bed size 0/3
Post-process 0/3
Printer
FDM / FFF
File format
STL
Material
Min. bed size
50 mm (Small)
Software
Cura, PrusaSlicer, or similar
No ratings yet
No comments yet – be the first!

Similar Models

6 Suggestions
Phone Prop Fob - Phone Stand / Selfie Stand
Phone Prop Fob - Phone Stand / Selfie Stand
by Makers Mashup
↓ 37 ♥ 4
Bunny Phone Holder
Bunny Phone Holder
by C47_3D
↓ 48 ♥ 114
Keyring Phone Stand for Large Phones
Keyring Phone Stand for Large Phones
by bmatic
↓ 133 ♥ 11
Compact Foldable Phone Stand
Compact Foldable Phone Stand
by VC Design
↓ 319 ♥ 102
Clip on phone stand keychain adjustable
Clip on phone stand keychain adjustable
by Encrust3d
↓ 962 ♥ 184
Reindeer Phone Stand
Reindeer Phone Stand
by C47_3D
↓ 221 ♥ 463
Feed Blog Slicer Cost Calculator Image Search Submit Kontakt Discord ☕ Buy me a coffee
· Impressum · Privacy
DE EN FR ES IT NL

Add to Collection