Thingiverse
Phone Stand
von MasterKam
2
Downloads
3
Likes
0
Makes
A Mobile phone stand that you can print without supports.
LAy it on its side on the bed. There is a tiny little bit of overhang but I had no issues printing it without support. I printed with PLA, but PETG would be stronger I guess. Enjoy and don't forget to update the print count. Tell me if you liked it.
Support: None
Layer height: 0.15mm
PLA, PETG
LAy it on its side on the bed. There is a tiny little bit of overhang but I had no issues printing it without support. I printed with PLA, but PETG would be stronger I guess. Enjoy and don't forget to update the print count. Tell me if you liked it.
Support: None
Layer height: 0.15mm
PLA, PETG
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!