Thingiverse
Phone stand
von Nevik
8
Downloads
13
Likes
0
Makes
A wide phone stand (78mm or 3") made for a cell phone with a protective case (max 16mm or 0.63" thick).
Maybe it will work with some tablets.
The angle of the stand is 15 degrees.
Prints fine without support.
I used 50% infill, but you may get away with less.
Maybe it will work with some tablets.
The angle of the stand is 15 degrees.
Prints fine without support.
I used 50% infill, but you may get away with less.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
