Thingiverse
Phone Stand
door athinmaker
3
Downloads
3
Likes
0
Makes
Two tilt angles are available:
- 65 deg. (default)
- 60 deg.
Note:
Removing the support from the center of the stand can be challenging if printed vertically (recommended for a smooth, flat bottom). Heating a nail with a gas torch and using it to cut through the support is an option to make it easier, but be careful with the fumes.
- 65 deg. (default)
- 60 deg.
Note:
Removing the support from the center of the stand can be challenging if printed vertically (recommended for a smooth, flat bottom). Heating a nail with a gas torch and using it to cut through the support is an option to make it easier, but be careful with the fumes.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
