Thingiverse
phone stand
von p_farnsworth
1
Downloads
0
Likes
0
Makes
A simple stand for a smart phone. A charger cable can be plugged in while the phone is on the stand.
I printed it lying on the side, with some supports. This gave me the best surface finish.
I also attached a sheet of foam rubber on the bottom to get a firmer stand.
The foto show the stand printed with Galaxy Black PLA from PRUSA.
I printed it lying on the side, with some supports. This gave me the best surface finish.
I also attached a sheet of foam rubber on the bottom to get a firmer stand.
The foto show the stand printed with Galaxy Black PLA from PRUSA.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
