Phone/Tablet Variable Stand (v3)

This is the third version of "Phone/Tablet Pocket Stand". The new hinge is now completely redesigned with wing nut and bolt which can now be adjusted and tightened as desired. In addition, the hinge mechanism also offers variable tension for tightening if the joints gets loose.

Material(s) Needed:
-3D Printer
-1x Metric hex bolts, Stainless steel A-2, 6mm x 1.0mm x 60mm
-1x Metric wing nuts, Stainless steel A-2, 6mm x 1.0mm
-Optional rubber tape

Note:
-Almost any printer setting can work but hex bolt tolerance must be considered (.5mm tolerance included)
-All phones/tablets with thickness less than 10mm(1cm) will fit.
-All fasteners can be bought from www.boltdepot.com

Notes:
-Be mindful of wing nut, it must be flushed for the phone to lean.