Thingiverse
Phone tripod support
von Cascao
0
Downloads
1
Likes
0
Makes
Small support for tripod
you will need an 1/4" nut
print it with material that allow for some flex (PETG, ABS, etc) preferibelly because horseshoe format is suposed to spring a little to hold phone in place.
Best position for strenght is according picture attached.
https://www.crealitycloud.com/user/3883002307
you will need an 1/4" nut
print it with material that allow for some flex (PETG, ABS, etc) preferibelly because horseshoe format is suposed to spring a little to hold phone in place.
Best position for strenght is according picture attached.
https://www.crealitycloud.com/user/3883002307
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
