Thingiverse
Photo Studio background
von globso
6
Downloads
2
Likes
0
Makes
This is a photography studio background i have designed. the purpose is to put a 2mm floor mat in the slot of the stand to make it a fairly big background.
it can be clamped to a table whit the slots in the bottom, or you can screw it to a table through the 4 or 6 mm holes. or just stand on its own, as in the pictures.
- The holes for the rods that goes upwards and also from side to side are 1,5 cm aluminum rods.
- The fitting of the rods ar pretty tight but you still need to fasten them with a m5 bolt. therefore you will have to put m5 inserts in the holes where these fit, you will understand if you have worked withe these brass inserts before.
- nothing needs to be said about the printing, its pretty straight foreward laid flat on the bed, ad support where is needed. copy and mirror to make the opposite pair parts of the stand.
Enjoy:)
it can be clamped to a table whit the slots in the bottom, or you can screw it to a table through the 4 or 6 mm holes. or just stand on its own, as in the pictures.
- The holes for the rods that goes upwards and also from side to side are 1,5 cm aluminum rods.
- The fitting of the rods ar pretty tight but you still need to fasten them with a m5 bolt. therefore you will have to put m5 inserts in the holes where these fit, you will understand if you have worked withe these brass inserts before.
- nothing needs to be said about the printing, its pretty straight foreward laid flat on the bed, ad support where is needed. copy and mirror to make the opposite pair parts of the stand.
Enjoy:)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
