Thingiverse
Photon S air tip
door Peyrit
39
Downloads
23
Likes
0
Makes
This is a tip that adapt to the photon S back air vent. You can use it to plug a filter. I designed it to fit with this design :
https://www.thingiverse.com/thing:3681435?fbclid=IwAR20EggKz_uBXHu5Xv20cNm4v5Oy44Mn21KDMQhMpvueDqdRR7s9pb9Jtkk
(thank you makermatrix for making it!)
It was made to adapt a 3M 6001 cartridge as a filter for the photon. As the back of the photon S is different, I had to come up with something. And it actually works! I recommand making it with a partially flexible material, or the little claws will break (I printed it with anycubic grey resin and two claws broke during the installation, but it fit and doesn't move anyway, so... ).
Why the picture is a tape mess : the screw of the link above didn't worked well and the cartridge was falling, so I manadged...
PS : Delete the file after making it, it is wayyyy overweight. Or make it lighter. I couldn't.
https://www.thingiverse.com/thing:3681435?fbclid=IwAR20EggKz_uBXHu5Xv20cNm4v5Oy44Mn21KDMQhMpvueDqdRR7s9pb9Jtkk
(thank you makermatrix for making it!)
It was made to adapt a 3M 6001 cartridge as a filter for the photon. As the back of the photon S is different, I had to come up with something. And it actually works! I recommand making it with a partially flexible material, or the little claws will break (I printed it with anycubic grey resin and two claws broke during the installation, but it fit and doesn't move anyway, so... ).
Why the picture is a tape mess : the screw of the link above didn't worked well and the cartridge was falling, so I manadged...
PS : Delete the file after making it, it is wayyyy overweight. Or make it lighter. I couldn't.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
