Phykea End Table - Full sized Right table

My mother wanted to replace her end tables, so I made a set for her! Featured is only the right table, as the parts list becomes VERY confusing when you have mirrored parts that have the same name. If desired, the blender file is attached for those who wish to edit the table. This end table measures 26.5 inches in X and Y, and is 19 inches tall in Z. The printing volume needed for any of these parts is 280mm in any direction, though most parts are smaller than this. Please ensure your printer can make dimensionally accurate prints, as no clearances/tolerances were added.

This table features a built-in organizer, cable passthroughs, cable management, and a holding spot for both a laptop PSU and a power strip. The table's organizer features 2 pen holder bays, 1 paperwork/notebook tray, a rest for your controller, a rest for headphones, and a small pocket to hold a back scratcher, because why not. No screws, nuts, bolts, bearings, glue, or other fasteners should be needed to assemble the