Pi 0 Flex case for mini camera

I very much liked Allcity Maker's case, but needed to adapt it for the mini-camera. The cable for this is too long for the original design, and too short to fold, so I moved the camera mount to one end of the case.

When I came to put it together, most of the vertical pillars broke. I just don't seem to get on with thin vertical bits: they invariably come out the wrong size and, when I try to clean them up, they fall off.

I redesigned the Pi mount so it's held from both sides and has a shorter thin section. I had so much trouble with the camera mount, I put in a solid base with 2mm sockets. I inserted short pieces of cocktail stick into the sockets to hold the camera. Purists will cringe, but it works.

I also enlarged the GPIO socket to take an IDC header.