Pi Cam Hood

A simple lens hood for the raspberry pi camera.

Fits lens with barrel size of 7.3mm.
Designed in Fusion360 with lens interface of 7.5mm to account for tolerance. if too sloppy on your lens (due to printer being better than mine) just scale down the model by a tiny amount.

I noticed my time lapses where looking a bit washed out, after a bit of mucking around i found that the lights i have around my bench where shining in to the lens and causing some contrast issues...probably due to the plastic lens.

Prints without support in under 10 minutes.
i used 0.3mm layer heights on a 0.4mm nozzle but would probably benefit from smaller layer heights.