Pi Controllable Outlet Box

Project box to hole a computer controlled circuit based off the design i found here:
https://www.instructables.com/id/A-USB-Power-Controled-Plug-Strip-With-Isolation/

Instead of USB, I will connect it to a raspberry pi via a 2pin molex connector on the side hole. The front panel accepts a C13, C14, and 10 amp push button fuse. Which will allow it to all be modular.

I did a 100% infill, but i think its overboard. The 10% during mock up actually worked nicely, but i didn't test putting a screw in it, and i want as much bite as i can for the screws holding the components together. I should have marked out the screw holes for each component, but i didn't trust my measuring skills.

v3 will fit all the components, but its tight and not a lot of room to spare. Also the fuse hole was very tight.

v4 i added a couple centimeters down long axis to give more room. Also added 2mm all around the fuse so it fits much loser.

Make sure to pre-drill screw holes for the internal co