Thingiverse
Pi Gaming Rig Case
von deanbip
85
Downloads
48
Likes
1
Makes
I wanted a desktop case for the pi that would stand out. I was also very surprised to find that nobody has made a mini PC case for it. SO I MADE MY OWN!
TESTED AND WORKING. I HAVE PRINTED THE ORIGINAL CASE STL. TWICE WITH NO PROBLEMS.
This has slots to slide a 4"X4 1/2" X 1/8th inch plexi glass into the side window, also a mount for a 40mm fan in the front as well as 2 on the top.
This is a big case! plan for a long print but it gives plenty of room for other mods.
The bars across the window are for support. you can pretty much just snap them and clean up the top with a razor. Or print without window top and use a taller piece of plexi glass.
HINT: you may need to shave the lid hinge balls a little to get it in place.
TESTED AND WORKING. I HAVE PRINTED THE ORIGINAL CASE STL. TWICE WITH NO PROBLEMS.
This has slots to slide a 4"X4 1/2" X 1/8th inch plexi glass into the side window, also a mount for a 40mm fan in the front as well as 2 on the top.
This is a big case! plan for a long print but it gives plenty of room for other mods.
The bars across the window are for support. you can pretty much just snap them and clean up the top with a razor. Or print without window top and use a taller piece of plexi glass.
HINT: you may need to shave the lid hinge balls a little to get it in place.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
