Thingiverse
Pi tray
by jinx
4
Downloads
5
Likes
0
Makes
After running out of desk space I made this tray/shelve to home my PI..
its a little wasteful on supports! but will require supports "touching build surface" in cura.
ideally it meant to be printed at .3 layer height, you require for brass standoff to complete.
there two 5 mm holes for screws or just epoxy.
its a little wasteful on supports! but will require supports "touching build surface" in cura.
ideally it meant to be printed at .3 layer height, you require for brass standoff to complete.
there two 5 mm holes for screws or just epoxy.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!