Thingiverse
Pi Zero 2 W Case Mount for Ender 3
von llmrfox
112
Downloads
52
Likes
0
Makes
This is a v slot mount for the Pi Zero 2 case found here: https://www.thingiverse.com/thing:1167846
May need to print with a raft or brim to prevent warping on the mount overhanging support arm.
Should work for all Ender 3 variants. I have only tested it on my own Ender 3 V1.
Uses 2 M3 x 6mm screws to mount through the case into the mount base.
UPDATE V1.1: Added extra clearance to v-slot runners to allow for easier install on Ender 3 v2
May need to print with a raft or brim to prevent warping on the mount overhanging support arm.
Should work for all Ender 3 variants. I have only tested it on my own Ender 3 V1.
Uses 2 M3 x 6mm screws to mount through the case into the mount base.
UPDATE V1.1: Added extra clearance to v-slot runners to allow for easier install on Ender 3 v2
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
