Pi Zero Camera Caddie

Pi Zero & Camera Caddie
=====================

The purpose of the caddie is to mount a Pi Zero with attached camera to the v-slot rail at the height of the build plate at it's highest position and also at the height of the print head for *timelapse videos where you want to be able to see below the hot end.*

Sure, you could cable tie it to the frame at the same height, but seriously, let's over engineer a caddie to do the same job!

I created it to be free standing or you can bolt it to the v-slot rail using the 2x holes on the top edge. It has a cable channel for any GPIO pins if you were to make a top lid for it. There is a gap for the power and USB in the bottom of the caddie.

It's designed for a Pi Zero in a case, there are lots of cases but mine is a "Premium Raspberry Pi Zero case"

The caddie can also be mounted outside of the frame if you just want somewhere to hang your Pi Zero without a camera


Warning:
------------
I made this for my Ender 5 Pro, and it si