Thingiverse
Pi Zero W Mounting Case for Ender 3
by chand1012
61
Downloads
23
Likes
0
Makes
I needed a convenient place to mount my Pi Zero W so it could run Octoprint. I used the snap on clip design from the Filament Guide and the Case by geertvda to create this mountable case. This will limit the printable height by about 20mm, bringing the print volume of the Ender 3 to 220x220x230mm.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
