PiCam 1.3 Case for 3D Printer

Needed this for a PiCam 1.3, so hole for camera is square and offset.

V2 Position of square cutout adjusted.

OK, I remade the back, to fit the following bracket.... https://www.thingiverse.com/thing:2886101

I have now printed this and all is well. With this, and my OctoPi case top, if you're mounted under the Ender3 LCD panel, you'll need a ribbon cable about 1m long. This should allow slack.

I have held my case together with a small amount of tape, but a blob of glue on each pin should be fine.