PiCam GoPro Mount - OpenSCAD

**__Ko-Fi:__** [https://ko-fi.com/juliettaexpress](https://ko-fi.com/juliettaexpress)

---

GoPro mount combined with Raspberry Pi Cam mount to allow for a versatile selection of mounts and such. Dimensions taken from the following two links:

- [Specs page](https://www.raspberrypi.org/documentation/hardware/camera/)
- [Mechanical Drawing](https://www.raspberrypi.org/documentation/hardware/camera/mechanical/rpi_MECH_Camera2_2p1.pdf)

Re-created the relevant part of the design in OpenSCAD, using the 2-flap version of [an earlier GoPro mount design](https://www.thingiverse.com/thing:3088912) that I finally got around to isolating and taking measurements from the official PiCam mechanical drawing. Should make mounting my [MotionEyeOS](https://github.com/ccrisan/motioneyeos/wiki) setup a snap!

---

### Recommendations
- Print with high infill for security of the GoPro mount
- M2 hardware
- Use eight nuts rather than four, with one set serving as standoffs to prevent the pl