Thingiverse
PiCam holder for Blocks Zero
door casualTanker
3
Downloads
3
Likes
0
Makes
A simple holder for the PiCam v2, that simply clips on to the frame of the Blocks Zero 3D printer. Camera case should be assembled with at least two 10mm M2 screws w/nuts. Beneficial with a longer PiCam cable than the standard 15cm one. You also need to make feet for the Blocks Zero, to run the USB cable from the Raspberry Pi (or the like) to the printer board. For instance: https://www.thingiverse.com/thing:2925073
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
