Thingiverse
Picatinny Battery Box
door ABCDOMG
12
Downloads
2
Likes
0
Makes
Battery Box rail mountable to Picatinny.
Designed for 100x34x15mm Minitamiya batteries with a little wiggle room for one slightly bigger,
Internal measurements 111.5x38.5x18.1, squish at your own risk.
The hole at the top fits a Mini Tamiya connector through just fine, I suggest running the wire through the hole before putting the battery in the box.
Requires a short m3 nut and bolt to close compartment, 10mm suggested.
Requires an m3 nut and bolt to secure to rail, I recommend 30mm but 25mm "may" fit though I haven't tested it.
I would suggest minor supports and printing with one of the short sides on the build plate, depends how good your printer is at bridging.
Designed for 100x34x15mm Minitamiya batteries with a little wiggle room for one slightly bigger,
Internal measurements 111.5x38.5x18.1, squish at your own risk.
The hole at the top fits a Mini Tamiya connector through just fine, I suggest running the wire through the hole before putting the battery in the box.
Requires a short m3 nut and bolt to close compartment, 10mm suggested.
Requires an m3 nut and bolt to secure to rail, I recommend 30mm but 25mm "may" fit though I haven't tested it.
I would suggest minor supports and printing with one of the short sides on the build plate, depends how good your printer is at bridging.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!