Thingiverse
Picatinny Flashlight Mount - 28mm
by Permafrost
101
Downloads
112
Likes
1
Makes
*This is an early version I'll keep working on to iron out the post processing. It works as it is now, but I'm not fully satisfied *
Yet another picatinny to flashlight mount!
I tried to make it low profile, not too protruding or thick.
* **Ring diameter: 28mm **, with about ** + / - 2mm ** adjustement. It fits the widely available "XML T6" flashlight (often rebranded)
* Uses ** 2 M4 screws **, and ** two full nuts ** of the same diameter. I personnaly used ** one M4 x 12mm **, and ** one M4 x 25mm **, fits like a glove
* The female rail is a tight fit on my 3D printed picatinny rail. Your mileage may vary, that's what the screw is here for.
* ** Infill: 100% (with PLA) **: this is really important as flexibility and toughness have been calibrated with this parameter in mind.
Let me know if you encounter any kind of problem or if you need another diameter. I could add quite easily a few common diameters, to make it more "universal"
Yet another picatinny to flashlight mount!
I tried to make it low profile, not too protruding or thick.
* **Ring diameter: 28mm **, with about ** + / - 2mm ** adjustement. It fits the widely available "XML T6" flashlight (often rebranded)
* Uses ** 2 M4 screws **, and ** two full nuts ** of the same diameter. I personnaly used ** one M4 x 12mm **, and ** one M4 x 25mm **, fits like a glove
* The female rail is a tight fit on my 3D printed picatinny rail. Your mileage may vary, that's what the screw is here for.
* ** Infill: 100% (with PLA) **: this is really important as flexibility and toughness have been calibrated with this parameter in mind.
Let me know if you encounter any kind of problem or if you need another diameter. I could add quite easily a few common diameters, to make it more "universal"
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
