Thingiverse
Picatinny flashlight mount
1k
Downloads
671
Likes
6
Makes
I could not find a picatinny flashlight mount that I liked here so I designed my own based on a few designs combined.
This was designed for use with m3 hardware and you will need various length of bolts and 6 m3/equivalent or smaller nuts.
It should print just fine on its side without support or any other modifications.
Be sure to print with at least 85% infill for optimal structural integrity.
I'd love to see your application of this thing. So if you want to post some pictures, I would love to see!
This was designed for use with m3 hardware and you will need various length of bolts and 6 m3/equivalent or smaller nuts.
It should print just fine on its side without support or any other modifications.
Be sure to print with at least 85% infill for optimal structural integrity.
I'd love to see your application of this thing. So if you want to post some pictures, I would love to see!
holydeltawings also publishes on
1 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
