Thingiverse
Pickup Select Switch Knob
von ottaross
71
Downloads
61
Likes
0
Makes
A replacement knob for an electric guitar pickup select switch. This was for my strat copy, but I suspect it will work for a variety of pickups switches.
It prints very quickly and seemed to work well, once I got the hole sizing right. Hope it works for you. Good news is that at less than a gram and printing very quickly, there is not much time to be wasted in finding out.
The switch I used it on has approx a 1.3mm x 7mm rectangular cross section.
It prints very quickly and seemed to work well, once I got the hole sizing right. Hope it works for you. Good news is that at less than a gram and printing very quickly, there is not much time to be wasted in finding out.
The switch I used it on has approx a 1.3mm x 7mm rectangular cross section.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!