PiClop 3D Scanner

This is a modification of bqLabs CiClop 3D Scanner. I have changed it to accommodate a Raspberry Pi in place of the Arduino. I have not completed the electrical circuit or software.
Sketchup files are included.

Laser Mount
- relocated the nut so that it inserts from inside of the laser mounting hole this provides more material around the nut and makes it easier to remove if needed
- use an M3 bolt and nut

Turn Table Base
- removed the M8 nut traps, the original design did not allow for easy adjustment of the M8 bolt lengths, I have changed the design so that you can adjust this easier, I did recess the nuts on one side - you will need a socket for these
- added clips that bolt (25mm M5 hex bolts and nuts) in place to hold the bearing, these have nut traps on the underside acccessed from where the motor mounts
- removed foot locators
- removed all the extra supports (they are not needed for printing), the only supports are for the motor shaft and bolts and the beari