Thingiverse
Pico Dram Tester enclosure
von Attilan
0
Downloads
2
Likes
1
Makes
This is a Pico DRAM tester enclosure. Easy to print.
It also allows powering the board through a USB Type-C connector connected to the power pads on the circuit board for more stable operation.
For assembly, you will need one female USB Type-C connector and 2mm metal screws as shown in the photos.
There are two versions available: 15-degree angled and flat.
Note: Optionally, to position the LCD screen closer to the surface of the case as shown in the photos, the LCD screen may need to be soldered slightly higher.
It also allows powering the board through a USB Type-C connector connected to the power pads on the circuit board for more stable operation.
For assembly, you will need one female USB Type-C connector and 2mm metal screws as shown in the photos.
There are two versions available: 15-degree angled and flat.
Note: Optionally, to position the LCD screen closer to the surface of the case as shown in the photos, the LCD screen may need to be soldered slightly higher.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!