PicoBETH HW2 Part-C 3D-Printed version

#### 🌐 English Version

The 3D-printed version of **Part-C for the PicoBETH HW2 hardware layout**, an open-source badminton stringing machine, simplifies the assembly process and enhances the convenience of cable management.

- **M5 x 80mm screws x2 (for mounting to the Load Cell):** Please ensure the use of standard M5 washers and tighten with a torque value of 2N.m.
- **M4 x 16mm screws x4 (for mounting to the sliding table base):** Please ensure the use of standard M4 washers and tighten with a torque value of 1.5N.m.
- **Material:** Avoid using PLA, as its strength deteriorates over time. It is recommended to use high-strength materials for printing.
- **Infill:** This component is subject to significant stress; please set the infill density to 100% to extend its lifespan.

> **Note:** Failure to use washers or to follow the specified torque values may result in component damage. Please pay close attention!

For the complete assembly process of the PicoBETH badminton stri