Slicer Discord
Picture stand – 3D-Druckmodell von MakerWorld MakerWorld
Decor

Picture stand

von ARC3DTCTR · Decor
794 Downloads
187 Likes
546 Makes
Zum Modell
Hi Makers! Here we have a simple picture or card stand to always show your most important phrases and memories of life. You can use it to display any printed picture of maybe you or your family or just put in a card with a funny or smart message on it to make a smile on everyone's face when reading. The holder is a very small and minimalistic part to never catch any attention and therefore only partly serve as a decoration. Its internal notch is around 3mm wide and this way can hold a variety of different materials of cards. If you like you may also use the extra space to hold more than just one picture or message in the background, letting you freely switch after some time to always have fresh photos etc. visible for guests or just for you;-)I personally like to use thicker wooden cards like in the photos above, but you might have to check if the thickness will still fit and if the weight is low enough as it may fall over if the material is too heavy or too long to securely stand.
Kategorie
Decor
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA, Wood PLA
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen