Thingiverse
Pierre Governors Keychain
von cmalczew
2
Downloads
0
Likes
0
Makes
You need to print both halves.
I included the single and the duel layout. Print the duel layout and your done.
I provided the single one incase you have a small print area.
I used the post processing commands to stop at particular layers (the exact layer depends on your resolution) to do a color swap.
I found a keyring and then crazy glue the two halves using clamps for about 20 minutes. Solid.
Supports are NOT needed.
I included the single and the duel layout. Print the duel layout and your done.
I provided the single one incase you have a small print area.
I used the post processing commands to stop at particular layers (the exact layer depends on your resolution) to do a color swap.
I found a keyring and then crazy glue the two halves using clamps for about 20 minutes. Solid.
Supports are NOT needed.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
