PiFinder V3 - Threaded Camera Holder

This is a threaded camera adapter for the PiFinder V2.5 / V3 for folks printing at home. Threads are tight but should be workable if your printer is well calibrated (I printed on an X1C without any issue) NOTE: when you thread in the camera lens the first few times you need to press it in fully then wind it backwards until you feel/hear it click, this is the lens dropping into the threads, once you feel this wind it it normally ~6mm and it should be snug. If you cross thread it, expect to reprint as these have a .5mm thread pitch… This is lifted from the Official PiFinder Github Repository and their Fusion 360 Model: https://github.com/brickbots/PiFinder/blob/release/case/PiFinder_DIY_v3.f3zI did not design this part but modified what was published by Brick Bot Labs