Thingiverse
PiggyBank
por C47_3D
9
Descargas
30
Likes
0
Makes
**Piggy and Boar cubes for your savings**
---
**More PiggyBanks:**
**Piggy Bank Vault (wich this model was based on):**
---
100x100x109mm
No supports needed
No glue needed for assembly
Eyes and a smile will snap together with base model
Original models are with a lid (printed separately) but there is a version without it too (you will need to break a piggybank to get the money then)
If you don't have a good cooling on your printer you can print a base and a face separately - use PARTS files then
Face should snap in to base model but those models were not print tested. In the worst case you will need to use a glue
---
---
**More PiggyBanks:**
**Piggy Bank Vault (wich this model was based on):**
---
100x100x109mm
No supports needed
No glue needed for assembly
Eyes and a smile will snap together with base model
Original models are with a lid (printed separately) but there is a version without it too (you will need to break a piggybank to get the money then)
If you don't have a good cooling on your printer you can print a base and a face separately - use PARTS files then
Face should snap in to base model but those models were not print tested. In the worst case you will need to use a glue
---
C47_3D también publica en
64 modelos adicionales en 2 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
