Thingiverse
PikaCube
door Lokiestar
19
Downloads
12
Likes
1
Makes
Lets see how many of you can pull off this print and show us how well calibrated your 3D Printers are.
If you decide the supports are getting in the way just ask and i will upload the version of it with none but for a successful print i think it's best to have them on.
This prints with no supports and should print good enough on 0.2 at 147.22% original size.
For the hardcore calibration fanatics out there try it on 0.12 at 100% and lets see how you get on.....
This is a mashup and i wouldn't have even bothered making this without this awesome Pikachu model done by PatrickFanart.
Clip away the 1mm bars supporting the spring after the print has finished for a satisfying springy Pikachu!
If you decide the supports are getting in the way just ask and i will upload the version of it with none but for a successful print i think it's best to have them on.
This prints with no supports and should print good enough on 0.2 at 147.22% original size.
For the hardcore calibration fanatics out there try it on 0.12 at 100% and lets see how you get on.....
This is a mashup and i wouldn't have even bothered making this without this awesome Pikachu model done by PatrickFanart.
Clip away the 1mm bars supporting the spring after the print has finished for a satisfying springy Pikachu!
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
![A normal cube [CALIBRATION TEST]](https://wsrv.nl/?url=https%3A%2F%2Fmakerworld.bblmw.com%2Fmakerworld%2Fmodel%2FUS843d9738523cb0%2Fdesign%2F2025-03-26_db8415cde5f3d.png&w=400&h=300)
