Thingiverse
Pill Box Labels
by falconman
2
Downloads
2
Likes
0
Makes
The printed labels on my weekly pill organizer wore off, so I created a set of labels that would physically attach.
Print the design out. I used .2 layer height and 10% infill. Drill a 3mm hole in each compartment and press the peg on the back of the labels into the hole. Then use a soldering iron or other heat source to melt the peg like a rivet to fasten the lablel in place.
To get two color, I added a pause (M600) by manually editing the gcode file and placing the command just before the "LAYER:4" label.
Print the design out. I used .2 layer height and 10% infill. Drill a 3mm hole in each compartment and press the peg on the back of the labels into the hole. Then use a soldering iron or other heat source to melt the peg like a rivet to fasten the lablel in place.
To get two color, I added a pause (M600) by manually editing the gcode file and placing the command just before the "LAYER:4" label.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
